Synthesis, optical and morphological characterization of soluble main chain 1,3,4-oxadiazole copolyarylethers—potential candidates for solar cells applications as electron acceptors

New copoly(arylether)s containing substituted terphenyl, quinquephenyl, fluorene and anthracene moieties with aromatic 1,3,4-oxadiazole units were prepared and the resulting copolymers are soluble in common organic solvents. Investigation of their optical properties revealed that they emit blue and yellow light. Moreover, their photovoltaic response was studied in blends with poly(3-hexylthiophene) (P3HT) as the electron donor. Despite the low power conversion efficiencies it was shown that photo-induced electron transfer does take place and the performances are higher than a single layer P3HT device. In addition, an anthracene-fluorene-oxadiazole main chain copolymer (PAFOXD) was also examined in a single layer photovoltaic device and gave one of the highest reported open-circuit voltage (V_oc) values in the literature (0.89 V). Finally, a detailed morphological study of the blends and the PAFOXD surface using the atomic force microscopy (AFM) technique, revealed the effect of solvent selection to the preparation of thin films exhibiting the desired performance characteristics.     

Evaluation of hydrogen producing cultures using pretreated food waste

In order to enhance bio-hydrogen production from food waste, pretreatment methods are widely used. The influence of the initial pH and autoclaving were investigated in batch experiments. Fermentative studies showed that pure cultures like Clostridium beijerinckii could directly utilize raw food waste to produce hydrogen, while other cultures (Clostridium butyricum and Clostridium pasteurianum) could produce hydrogen only after pH adjustment. In this case, the optimal starting pH of the culture was found to be 7. Autoclaving could further enhance hydrogen yields due to increased hydrolysis of food waste. The maximum hydrogen yield was achieved by C. butyricum (38.9 mL-H₂/g-VS_added) after autoclaving food waste with pH adjustment at 7. In addition, the ratio acetic to butyric acid was decreased by autoclaving pretreatment, because butyrate metabolic pathway was favored in the fermentation process. However, suitable pH for bacteria growth and the low ammonia production could be achieved from autoclaving food waste.     

Synthesis and biological investigation of novel tricyclic benzodiazepinedione-based RGD analogues

Integrins, a widely expressed family of heterodimeric cell surface adhesion proteins, are expressed in a variety of cell types. They play a decisive role in cell-cell adhesion or cell to extracellular matrix adhesion events. Antagonists of alpha(v)beta(3) or alpha(IIb)beta(3) integrin may have a potential use in suppression of pathological processes. We present the synthesis of novel tricyclic benzodiazepinedione-based RGD analogues, which were subsequently tested in a solid-phase receptor assay in order to investigate their binding affinities towards alpha(v)beta(3) and alpha(IIb)beta(3) integrin.     

Artificial neural networks for discriminating pathologic from normal peripheral vascular tissue

The identification of the state of human peripheral vascular tissue by using artificial neural networks is discussed in this paper. Two different laser emission lines (He-Cd, Ar+) are used to excite the chromophores of tissue samples. The fluorescence spectrum obtained, is passed through a nonlinear filter based on a high-order (HO) neural network neural network (NN) [HONN] whose weights are updated by stable learning laws, to perform feature extraction. The values of the feature vector reveal information regarding the tissue state. Then a classical multilayer perceptron is employed to serve as a classifier of the feature vector, giving 100% successful results for the specific data set considered. Our method achieves not only the discrimination between normal and pathologic human tissue, but also the successful discrimination between the different types of pathologic tissue (fibrous, calcified). Furthermore, the small time needed to acquire and analyze the fluorescence spectra together with the high rates of success, proves our method very attractive for real-time applications.     

Deploying LiveWN Grids in the Greek School Network

A determinant factor for the introduction of grid technologies in production domains of scale can be the design of easy, fast and, from an operational point of view, realizable deployment procedures. Remote system management technologies, typically used to monitor and manage IT environments, are designed to offer remote software installation functionality that exhibits the aforementioned characteristics; however, previous work has shown that even valuable systems can fail to perform in heterogeneous, geographically distributed environments, especially if they are maintained by organizations affiliated to the public sector. The deployment of grid technologies throughout the Greek School Network can be achieved by combining OpenRSM, a novel open source solution capable to support usable, configurable, infrastructure management use cases in heterogeneous environments and LiveWN, a grid scavenging solution that integrates live technologies with gLite grids.     

Electrochemical oxidation of stabilized landfill leachate on DSA electrodes

The electrochemical oxidation of stabilized landfill leachate with 2960 mg L(-1) chemical oxygen demand (COD) over a Ti/IrO(2)-RuO(2) anode was investigated in the presence of HClO(4) as the supporting electrolyte. Emphasis was given on the effect of electrolysis time (up to 240 min) and temperature (30, 60 and 80°C), current density (8, 16 and 32 mA cm(-2)), initial effluent's pH (0.25, 3, 5 and 6), HClO(4) concentration (0.25 and 1M) and the addition of NaCl (20 and 100mM) or Na(2)SO(4) (20mM) as source of extra electrogenerated oxidants on performance; the latter was evaluated regarding COD, total carbon (TC), total phenols (TPh) and color removal. Moreover, the anode was studied by scanning electron microscopy and cyclic voltammetry. The main parameters affecting the process were the effluent's pH and the addition of salts. Treatment for 240 min at 32 mA cm(-2) current density, 80°C and the pH adjusted from its inherent value of 0.25 (i.e. after the addition of HClO(4)) to 3 yielded 90% COD, 65% TC and complete color and TPh removal at an electricity consumption of 35 kWh kg(-1) COD removed. Comparable performance (i.e. 75% COD reduction) could be achieved without pH adjustment but with the addition of 100mM NaCl consuming 20 kWh kg(-1) COD removed.     

Fluorescent protein tomography scanner for small animal imaging

Microscopy of fluorescent proteins has enabled unprecedented insights into visualizing gene expression in living systems. Imaging deeper into animals, however, has been limited due to the lack of accurate imaging methods for the visible. We present a novel system designed to perform tomographic imaging of fluorescent proteins through whole animals. The tomographic method employed a multiangle, multiprojection illumination scheme, while detection was achieved using a highly sensitive charge-coupled device camera with appropriate filters. Light propagation was modeled using a modified solution to the diffusion equation to account for the high absorption and high scattering of tissue at the visible wavelengths. We show that the technique can quantitatively detect fluorescence with sub millimeter spatial resolution both in phantoms and in tissues. We conclude that the method could be applied in tomographic imaging of fluorescent proteins for in vivo targeting of different diseases and abnormalities.     

Washing enhanced electrokinetic remediation for removal cadmium from real contaminated soil

The main objective of this study is to evaluate the combination of electrokinetic remediation and soil washing technology in order to remove cadmium from contaminated soil. This paper presents the results of an experimental research undertaken to evaluate different washing and purging solutions to enhance the removal of cadmium from a real contaminated soil during electrokinetic remediation. Two different experimental modules were applied in the laboratory. Soil was saturated with tap water, while acetic and hydrochloric acids, as well as ethylenediaminetetraacetic acid (EDTA) were used as purging solutions in the first module. Results show that there was a decrease of cadmium concentration near anode, but a significant increase in the middle of the cell, due to the increasing pH. Citric, nitric and acetic acids were used for soil washing and purging solutions in the second module. In this case, an 85% reduction of cadmium concentration was achieved. Therefore, results indicate that soil pH and washing solutions are the most important factors in governing the dissolution and/or desorption of Cd in a soil system under electrical fields.     

Aristoforin, a novel stable derivative of hyperforin, is a potent anticancer agent

Hyperforin, a natural product of St. John's wort (Hypericum perforatum L.), has a number of pharmacological activities, including antidepressive and antibacterial properties. Furthermore, hyperforin has pronounced antitumor properties against different tumor cell lines, both in vitro and in vivo. Despite being a promising novel anticancer agent, the poor solubility and stability of hyperforin in aqueous solution limits its potential clinical application. In this study, we present the synthesis of hyperforin derivatives with improved pharmacological activity. The synthesized compounds were tested for their solubility and stability properties. They were also investigated for their antitumor properties, both in vitro and in vivo. One of these hyperforin derivatives, Aristoforin, is more soluble in aqueous solution than hyperforin and is additionally highly stable. Importantly, it retains the antitumor properties of the parental compound without inducing toxicity in experimental animals. These data strongly suggest that Aristoforin has potential as an anticancer drug.